WARRANTY
This Limited Warranty supercedes all previous RWII warranties and is exclusive, with no other guarantees or warranties expressed or implied.
Your RWII is warranted to be free from defects in material and workmanship for a period of two years from the date of the original purchase (proof of purchase required). This warranty covers only failures due to defects in material or workmanship which occur during normal use and does not cover damage which occurs in shipment or failures which result from accident, misuse, abuse, neglect, mishandling, misapplication, alteration or modification of the product, or damage that is attributable to acts of God.
The warrantor shall not be responsible for any incidental or consequential damages resulting from the use of this product, or arising out of any breach of this warranty. All express and implied warranties, including the warranties or merchantability and fitness for a particular purpose, are limited to the applicable warranty period set forth above.
IMPORTANT NOTICE: Certain states do not allow the exclusion or limitation of incidental or consequential damages or limitations to the length of an implied warranty, therefore the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
SAFETY
READ THESE WARNINGS - PROTECT YOURSELF AND OTHERS
BE AWARE, SERIOUS INJURY OR DEATHmay result if welding and cutting equipment is not properly installed, used and maintained. Misuse of this equipment and other practices can be both hazardous and dangerous to the operator and any persons in the general work area. The operator, supervisor and helper must read and understand the following safety warnings and instructions before installing or using any welding or cutting equipment.
The welding and/or cutting process is used in many potentially dangerous and hazardous conditions. In environments such as elevated heights, areas of limited ventilation, close quarters, around water, uncertain power sources, in hostile environments, etc., it is important that the operators are aware of the dangers and limitations associated with working in these types of conditions. Only properly trained and experienced operator(s) trained in safe practices for the environments in which they are expected to work and are under competent supervision should use this welder. It is essential that the operator, supervisor and others in the work areas are aware of the dangers of the welding or cutting process. Training and supervision are both important and necessary for a safe work place.
Please keep these instructions for future use and reference.
BE AWARE, THE FOAM IN THE RWII CASE IS FLAMMABLE.
Make sure the case is a sufficient distance from welding and cutting activity and is closed to avoid sparks, slag or any hot material from coming in contact with the foam.
ELECTRIC SHOCK CAN CAUSE INJURY OR DEATH
Install and maintain equipment in accordance with the National Electric Code NFPA 70 and local codes. Do not service or repair equipment with power on or batteries connected. Do not operate equipment with protective insulators or covers removed. Service or repair to equipment must be done by qualified and/or trained personnel only.