|
 Proudly Support |
 |
 |
 |
| Recent News |
| Nicole Johnson Sponsorship | | Anaheim, CA – April 1st, 2009
As Ready Welder entered the 2009 year, the organization knew it was..Read more |
|
| As Seen In |
|
  |
| Model #10250 |
 The RWII Model #10250 is cabled similar to other spool guns as the primary intention is to use this model as a spool gun attachment to the welding machines which already have a built-in ground wire or clamp. The Model 10250 also comes with the AC/DC Power Converter for welding with CC (constant current) stick machines. The Model 10250 will connect to all DC output welders as well as batteries (Please note that batteries require additional cabling.). This model is primarily used by welders wanting a spool gun attachment to their engine drives, MIG machines and stick machines (i.e. an attachment to run off your Miller, Lincoln, Hobart, and ESAB machines). This model is an excellent choice for welders that have engine drives or those that weld aluminum in the shop connected to a MIG or Stick machine. The Model 10250 is about 1/3 of the cost of most other manufacturer’s spool guns. The Model 10250 has a one year 100% parts and labor limited factory warranty. |
| 10250 Features |
Ready Welder II Case Includes |
- Cabled
as a spool gun
attachment for all
DC output welders
- Welds
Steel, Stainless and
Aluminum or Any
Metals Where
Standard One or Two
Pound Spools are
Available
- Connects
to Batteries
– 18 Volts
Can do Thin Sheet
Metal
– 24 Volts will
Single Pass
1/2" @ 275 amp
– 36 Volts will
Weld up to 3/4"
@ 350 to 400 amp
- Welds
22 Gauge to 3/4"
- Ground
Cable not supplied
- Connects
to MIG/Constant
Voltage,
Stick/Constant
Current Welding
Machines
- AC
to DC Power
Converter to Drive
Gun Controls When
Connected to
CC/Stick Machines
- Uses
Wire Sizes from .023
to .045 without
Changing Rollers
- Uses
Heavy-Duty TWECO
Quality Front End
Consumables
- Wire
Speeds of 50 Inches
to 900
Inches per Minute
- Polarity
Indicator Lights
- Twenty
Foot Cable with
Quick
Disconnects, Can be
Extended to 100 Feet
- Built-in
Gas Valve
|
- RWII
High-Impact MIG Gun
- Twenty
Feet of Cable
- One
Spool of Flux Core
Wire
- Two
Battery Clamps
- Extra
Tips and Gas Hose
Fitting
- Ten
Extra Feet of Gas
Hose
- Foam
Lined Blow-Molded
Tough Briefcase
- AC
to DC Power
Converter Supply to
Drive Gun Controls
|
|
|
|
